Address Table

Top  Previous  Next

Machine|Address table

 

In the address table all PLC-addresses that are used by the machine are united. Please do not mix up the address table with the symbol table, with which you can assign symbols to the PLC-addresses.

 

You can change the element names and the addresses. In extras|options|PLC-editor|rewire it is adjustable whether the addresses in the PLC-program shall be changed automatically.

 

The table can be sorted according to elements, addresses and element-types. Doing this click the corresponding column heading. If you click left it will be sorted automatically in ascending order, if you click right you will be able to decide whether the order shall be ascending or descending.

 

Out of the address table you will be able to reach the edit mask of an element directly if you select ‘edit’ out of the context menu.

 

If you want to check the use of an operand in the PLC you will have to click right and select ‘cross reference’ out of the context menu. The cross reference list will then be opened at the right position and from there you will get to the desired program position with a double click.

 

If you want to edit the symbol or the comment to the operand you will have to click right and select ‘symbol table’ out of the context menu.

 

You reach the address table by the little button ‘addr’ on each interface panel as well.

 

You print out the active table with project|print out.

 

In the column for the operand ‘E’, ‘A’ and ‘M’ as well as the point can also be entered above the number block.