Speed Trigger

**

With the help of this element you can modify the simulation speed automatically. By specifying a bit to the PLC you can activate slow motion resp. quick motion.

There are four trigger possibilities:

1.) Rising edge. Here the speed will be set to the selected value once at the rising edge of the bit.

2.) Falling edge: similar to 1.)

3.) ‘Always on 1’: Here the speed will be set to the specified value at a rising edge. If the speed is not changed till the falling edge (by another speed trigger or by the rabbit/turtle), the old speed will be set again when the signal disappears.

4.) ‘Always 0’: like 3.)

You can also select that the simulation is to be stopped completely as soon as the trigger conditions occur.

The sample ‘osci’ demonstrates the use of a speed trigger.

See also:

Slow motion

Breakpoints

Common properties

Static elements of simulation

Tabsheet: Tools